limiter

Transient designer before limiter

Transient designer before limiter
#AudiotentTip 100. Transient designer before limiting.
Have you ever applied a touch of limiting on you bus channel to control the peaks? In some cases this works great. Other times, you end up getting the signal to sit just right, but the punch of the transients is reduced.
Before you start pulling the threshold right up, try adding a transient designer prior to limiting and increase the transient attack. This should add some 'forwardness' back to your signal.
If you're looking for pure drum hits with all their dynamics intact checkout our Ultimate Synth Drums below.

[button type="flat" shape="rounded" size="regular" href="https://www.audiotent.com/ultimate-synth-drums/" title="Click Here"]Listen and learn more here[/button]


Enter your email address below and we’ll send you a selection of our samples. Free of charge!
As a thank you for signing up you’ll also receive an exclusive 10% Discount Code to use in our store.
[cp_modal display="inline" id="cp_id_92b91"][/cp_modal]

Reading next

Removing clicks and pops from your audio
Using macros

Leave a comment

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.