#AudiotentTip 014. Reverb technique to effectively introduce sounds:
Isolate the first part of your loop/vocal/synth shot, apply a fairly long reverb to it and bounce to audio. Now, reverse the new part and connect it to the original sound. This makes a smooth introduction of a new sound. Make sure to trim the transient from the reverse reverb, so you don’t get double transients.
If you have any questions about this tip, please leave a comment bellow...
Isolate the first part of your loop/vocal/synth shot, apply a fairly long reverb to it and bounce to audio. Now, reverse the new part and connect it to the original sound. This makes a smooth introduction of a new sound. Make sure to trim the transient from the reverse reverb, so you don’t get double transients.
If you have any questions about this tip, please leave a comment bellow...
Leave a comment
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.